Model 740LWF-WFAA

Name: 740LWF-WFAA Lighted Windsock Frame Beacon
Availability: InStock

12 volt lighted windsock frame with FAA approved aircraft anti-collision top beacon

Overview

BDS’s internally lighted windsock frame with 12 volt, linear super-bright white LED light assembly and an FAA approved aircraft anti-collision LED top beacon/obstruction light. Model 740LWF-WFAA is used with our Model 740ACCU or Model 740ACCU-PC power control unit.

The frame is an electro-mechanical assembly with an outer ring for mounting the windsock. A 4 inch square tubing assembly houses the electronics and is used for mounting the LED light assembly. Delrin type bearing hubs permit the frame to rotate 360 degrees as wind direction changes. Electronics inside the tubing assembly transfers power to the windsock light assembly.

Our 740 series systems have a 12 volt, linear super-bright white LED light assembly. The light assembly/bulb is ON whenever power is supplied from a power source.

Several different top beacons are available (see other models within the 740 Series).

Our standard windsock frame is 18” in diameter. 24” and 36” diameter frames are available on special order.

Specifications

Ditto Model 740LWF except with a 12 volt FAA approved aircraft anti-collision LED top beacon/obstruction light. The top beacon/obstruction light has 32 bright white lights that flash ON and OFF (approximately 0.25 seconds ON and 1.25 seconds OFF). Top beacon is installed on the mounting pipe above the windsock frame.

Model 740LWF-WFAA is used with our Model 740ACCU or Model 740ACCU-PC power control unit.
FRAME assembly – 18” standard diameter (24” and 36” frames available on special order).
Light output SAE (Society of Automotive Engineers) class 1 – LED’s life span better than 50,000 hours.
12 volt, linear super-bright white LED light assembly. LEDs shine into the mouth of the windsock.
Special electronics are installed inside the frame’s tubing assembly to transfer power to the lights. No mercury used.
Heavy duty construction – 4 inch square vinyl tubing with Delrin type bearing end hubs, and 304 welded stainless steel. Top rain cap.
Windsock mounting ring offset from main tubing assembly by approximately 11 inches (front to back).
Windsock light assembly mounts on center tubing assembly and does not restrict air flow.
22-feet of interconnect wiring is supplied from windsock lights to Control Unit.
A 1” NPT connection is on the bottom of frame assembly for connection to 1” or larger support pipe supplied by others.
A ¾” NPT connection is on the top of frame assembly for installing the top beacon.
Weight: 9 pounds (4.08kg).
Specifications subject to change without notice.